|| NCASE M1
Exterior: 1.5mm brushed anodized aluminum
Interior frame: 1.5mm powder coated aluminum
Interior fan bracket: 1mm powder coated steel
|| Mini-ITX, Mini-DTX
・3 x 3.5" Mounts:
x1 on case floor
x2 in removable side bracket
(cannot be used with dual radiator or ATX PSU)
・3 x 2.5" Mounts:
x1 inside chassis front
x1 behind front panel (in place of optical drive)
x1 on case bottom (in place of 3.5" drive)
Included double-stacking bracket allows 2 x 2.5" drives on
(depending on drive thickness)
|| 2x サイド 120mm
2x ボトム 120mm
1x リア 80/92mm
|| ATX , SFX
2 x USB 3.0, HD Audio
Top-down coolers are recommended.
Height restriction: 130mm (with side bracket in place and no fan mounted)
Cooler cannot extend past the top of the board by more than 10mm. For many larger coolers, this limits motherboard choice to those with centrally-located sockets.
Large coolers that extend past the front of the board will prevent the 3.5" HDD cage from being used.
Sealed liquid coolers or integrated pump/block and radiator/res recommended.
Single 120mm or 240mm radiators only.
A 240mm radiator on the side bracket will prevent use of ATX power supplies or the dual 3.5" HDD cage.
Recommended maximum radiator length: 290mm (303mm available internally, however the chassis lip makes 290mm+ difficult. Utilizing the inside front 2.5" drive mount also limits radiator length).
Recommended maximum thickness of radiator+fans: 60mm (85mm total available between side bracket and SFX bracket)
Rear exhaust cards recommended, especially for cards with TDP greater than 150W. Look up your card's TDP (external link).
Max length: 12.5" (slots 1 & 2), 11" (slot 3)
For cards up to 12.5" or cards in the third slot: 4.4"
For cards up to 11.5" in the first or second slot: 5.5" (4.7" at the PCIe power connectors)
SFX PSU support is standard
SFX-L (SFX extended to 130mm long) is possible using the v3 and later SFX bracket, which has been revised specifically for models based on the Sirfa/High Power unit, which include:
Sharkoon SilentStorm SFX Gold
High Power SFX-L500GD
Please note that due to the limited space available, SFX-L is a tight fit when used with long GPUs.
ATX PSU support is possible using the included bracket with the following limitations:
Cannot be used with the dual 3.5" HDD cage or 240mm radiator mounted to the side bracket (120mm radiator is still possible over the motherboard area)
Up to 160mm modular PSUs may be used with short GPUs (under 195mm long)
To use an ATX PSU and GPU over 195mm, the PSU can not be longer than 140mm and must be non-modular. It is not recommended to use an ATX PSU with a long GPU, due to the excess cables.
The AC inlet orientation on some ATX power supplies may prevent the angle plug from fitting, please check carefully. See this image. Note: the included AC cable has been changed from right-angle to left-angle for v2 and later.